Battery Reconditioner / Desulfator 48V /36V forklift battery

タイトルまたは説明

BatteryCare Battery Desulfator / Reconditioner for Electric Forklift *6V / *8V

Battery sulfation takes place when a lead-acid battery discharges. The lead from the plates combines with the electrolyte (dilute sulphuric acid) to make lead sulfate. When the battery is recharged this process is reversed however, some of the lead sulphate will crystalise on the lead plates. The deeper the battery is discharged, the more the lead sulphate is likely to crystalise acting as an insulator and reducing the plate area in contact with electrolyte. Over time this build up of lead sulphate crystals will kill the battery.

Reconditioning a Lead Acid Battery

Desulfation(also know as Reconditioning) offers a way for dead batteries to be brought back to life and for tired batteries to be rejuvenated. Desulfation will not bring batteries with a shorted cell, or worn out plates back to their former glory, but it is a valuable tool for anyone depending on battery storage for power who cannot afford to buy new batteries.

When lead sulphate crystals build up on the lead plates, it is not an easy task to remove them and thereby recondition the battery. As more and more crystallisation occurs, the voltage required to shift the crystals (dissolving them back into the electrolyte) also increases. But, if you were to put a constant high voltage through the battery it would overheat and could potentially explode. Pulse conditioning is therefore used to ensure that only the sulphate crystals are affected and the battery does not overheat.

Every lead acid battery has a resonant frequency. If sufficiently pulses of electricity (high frequency, high voltage, but low power) are sent into the battery, rhythmic beating (resonance) of the plates causes the crystalline deposits to break up and the sulphate returns to the electrolyte solution. This process can take a matter or weeks during which time the battery must be trickle charged (in parallel with the desulphator) so that the battery ends up reconditioned and fully charged.
Note that the voltage measured across the battery terminals will drop as the desulphation takes place as the internal resistance of the cells is reduced by the clearing of the crystals on the lead plates.

BatteryCare Desulfator utilized this technique to recondition the sulfated or dead lead-acid battery.

FEATURES  

• Reconditioning all Starter Battery and Deep Cycle Battery, with lead-acid wet cell , maintenance-free, AGM or VRLA  and Gel type of  2 V.  6 V.  8 V. and *2 V. *6V *8V battery..  This Desulfator can use to recondition all type of Car battery , Truck battery, Bus battery, Forklift battery, Golf Kart Battery, ATVs and Motor Sport battery,Computer UPS battery and Telecom UPS battery.
• The reconditioning time will be ****4 hr. depend on the size of the battery and the lead sulphate crystallization.
• The D.C. Amperage to recondition the sulfated battery can be adjusted 0 **5% of the AH rating of the battery by the volume adjuster on front panel, and displayed on the D.C. Ampmeter.
• The D.C. charge voltage be displayed by the D.C. Voltmeter, can be adjusted between *2.0 – *8.*0 Volt by the volume adjuster on front panel.
• Recondition multiple of  *5 - *5 AH  :  ****0 batteries simultaneously at one time.
• Recondition multiple of  **0 – **0 AH  :  **8 batteries simultaneously at one time
• Recondition forklift battery up to ***0AH 
• Consume only  AC **0V  *0A  at ***0AH of battery
• User friendly , easy to use, just clip the positive and negative clip terminal to the battery terminal, and adjust the amperage on the adjuster on front panel to about *0% of the batteries rating, then wait and check periodically the battery voltage, battery CCA and the internal resistance of the reconditioning batteries.

See Video from  youtube:

Telecom UPS Battery Desulfation   Part 1   Part 2<<< click

Inside Transparent Battery During Desulfation   Part 1   Part2 <<< click

Forklift Battery Desulfation  << click

Golf Kart Battery Desulfation  <<< click