copper cathode stripping machine used for stripping copper automatical

タイトルまたは説明

1. Functional Description

    Copper is deposited electrolytically onto blank cathodes in electrowinning cells located in the tank house. Loaded cathodes are periodically removed by an overhead crane with lifting bale and delivered to copper cathode stripping machine. The cathodes hang vertically from the bale and are deposited on the receiving station of copper cathode stripping machine. While on the receiving conveyor, the loaded cathodes are cleaned with high pressure and temperature water spays to thorough wash all surface. After passing through the wash booth, the loaded cathodes are transferred from the receiving conveyor to the stripping station to remove the copper. The stripped cathodes are transferred to a reject conveyor, and damaged or non-stripped cathodes are transferred to the discharge conveyor. Stripped copper is sampled, weighed, bundled, strapped, labeled and removed by forklift.

 2. Structure
3. Parameters and Requirements of a specific machine(Designed as per buyer)

1) Design capacity: **0 cathodes per hour

2) Noise level: *0dB dB (A) at most within 1 meter from motor and pump, but the stripping zone sometimes higher

3) Washing effect: deposited copper surface clean, no electrolysis residue, no copper sulfate crystals, no other attachments. Wash water temperature ≤ *0 °C

4) The amount of washing water cycle: 1 circulating pump, a heat sink of *2m3, *0m3 / h,  cycle of changing the water is 1 day

5) Dimensions: length × width × height: about ****0 × ****0 × ***0mm (can be adjusted according to the site)

6) Total weight of approximately *4 tons

7) Stacking number: Standard ****6 block / stack (installed counter, set free), or the total thickness ≤ **0mm;

8) Power requirements

Power requirements: **0/**0V, *0Hz;

Control Power: *4VDC (s, lights, hydraulic solenoid valve control power supply, etc.);

The total installed power: **0 kW (need to be finalized after the basic design of the device);

9) Steam supply: ***0kg / h, **3.6 °C ,0.**0 .6 Mpa

*0) Fogging fan: about ***0m3 / h

*1) Hydraulic system

 Operating pressure: ***2Mpa

 Hydraulic unit cooling water

 - pressure   0.**0.*5Mpa

 - Temperature  ≤*2°C

 - Flow rate  About **0L/min

 -Hydraulic oil  ISOVG*6 anti-wear hydraulic oil

4.The work flowsheet: