Energy Monitor is a great tool to monitor the status of the renewable energy sources (e.g. wind turbines or Solar Panels) to the load. The voltage, current, power and energy are monitored. The resistance of the Load is also displayed. It is a great tool for comparing the performances of a wind turbine or a renewable energy system under different operating conditions.

While most Power Meters are designed for AC power line application, the EM*1 is designed to meet the needs of evaluating renewable energy system applications.

The energy displayed is the Energydelivered to the load immediately after the Energy Monitor is powered ON. The powered ON time duration is also displayed. The Powerdisplayed is the average power delivered to the Load.

A unique feature to display the instantaneous rotating speed of the wind turbine in RPM(rotation per minute) is implemented. A resistanceof value smaller than **0 Ohm should be connected to the “Load” terminal for the RPM function to operate normally. When the RPM speed is too low to be detected accurately, “0.0.0.0.” will be displayed. This RPM function is specially designed for our eWind Basic, eWind Advanced and eWind Power *-Phase wind turbines.

This meter can be used for the Maximum Power Point Tracking (MPPT). By adjusting the value of the Load resistance when the Power is displayed, we can observe a peak power at an optimum resistance value. The maximum power from the source can then be extracted. The resistance of the connected Load can be displayed.

You can press the “Function” to select the Data to be displayed in the following order:

Voltage -> Current -> Power -> Energy -> Rotation Speed -> Time (MM:SS) -> Time (HH:MM) -> Resistance -> Voltage again.

The LEDs on the right side show the function and unit that the 4 digits are displaying.

You may also select the “Scan” Mode to display :

Voltage -> Current -> Power -> Energy -> Rotation Speed -> Voltage again so that you can read them sequentially every 0.5 second.

The “Auto-OFF” mode turns OFF the LED display after 5 minutes to reduce the power consumption while the Energy Monitor continues to record the energy delivered to the Load. The “Scan” LED blinks to indicate this “Auto-OFF” mode.

The “Ohm” LED blinks to indicate the Battery level is low. You should replace the old batteries with new ones when it blinks.

The Resistance displayed by EM*1 is calculated by dividing the Voltage with the Current flowing through the internal Current Sense Resistor. Sufficient Voltage has to be applied to the Input terminals to get enough current for calculation..

When the polarity of the power is reversed, the “Reverse Polarity” LED is lit. You should reverse the polarity of the connections.

The Energy Monitor samples the voltage and current data ***0 times per second. The power and energy data are calculated and then averaged. All data are displayed as average data.