Factory price rubber vulcanization machine

タイトルまたは説明

Product Description
This machine is divided into two series: steam vulcanizing boiler series and hot air vulcanizing boiler series. Each series has three heating mediums: steam, electric and conduction oil.
 Our equipment which has advantages of stable and reliable performance is the most widely used steam vulcanizing boiler, the temperature, pressure and time can be controlled automatically and it also easy to operate. And the equipment can save *5% of energy than other traditional equipment.  
 Technology
 
Working principle for steam vulcanizing autoclave
       The steam enter into the steam diffusion tube by entrance of steam which at the bottom of the steam vulcanizing boiler and the entrance can be controlled by automatic valve. The steam diffusion tubes vertical arrangement in the bottom of the tank. The small holes which diameters are 3mm,4mm and 5mm on the steam diffusion tube are arranged according to certain rules and angel to ensure that the steam spread in the tank evenly. Thus it can prevent the different quality of the product because of the uneven steam. After set working procedures, the heating, heat preservation, vulcanization and etc can be finished by automatic control system. The equipment stop working and give alarm after all procedures finished.
Working principle for electricity steam vulcanizing autoclave


     Electric heated tubes are arranged in the bottom of the tank according to certain rules, the heat exchanger linked the electric heated tubes and the water channel. The height of the sink is 5~*5mm. The steam which produced by electric heated tubes and water spread from down to up evenly until turn into condensate water pour into the sink after touched the wall of tank and then heat again. The temperature of the tank evenly and the pressure has no error, so it can prevent the different quality of the product because of the uneven temperature and pressure. After set working procedures, the heating, heat preservation, vulcanization and etc can be finished by automatic control system. The equipment stop working and give alarm after all procedures finished.
 Insulation:
 
Thermal insulation method: Our equipment using external thermal insulation.
Thermal insulation material: Our equipment using glass silk and aluminum silicate.
    The galvanized sheets which will not rust in ten years welded and fixed around the equipment and built in insulation cotton to ensure make full use of heat energy. The thickness of the insulation cotton which around the tank is *0mm and the thickness of the insulation cotton which around the head of the equipment is *0mm. It has advantages of easy to transport, long time use without deformation, good insulation effect and low cost.   Advantages: 

1. Open door method: manual quick open door method. Turn the hand wheel, you can easily open or close the door and one person can easily complete all the steps.  Use a special material bearings and accessories, long time use without deformation and damage. Safe, efficient, simple, efficient and save labor. When the power outage normal open or close the door.

1. Sealing way: Inflatable silicone ring seal.When working with compressed air automatic inflatable seal, as long as there is  pressure inside, tank door does not leak out, and the greater the pressure, sealing  the better. After pressure relief, seal ring automatic return flange seal groove. Inflatable seal design make seal ring not easy to wear, more convenient to use, easy to maintain, sealing effect significantly better than the other way, long seal life.

1. Safety interlocking methods of the door of the tank:Automatic pressure safety interlocking method and Manual safety interlocking method, it solved the safety problem of wrong operation.