EP**1A

1.Product parameters:

2.Parts List:

3.Instructions for use:
1, Select the appropriate voltage and connector for the electronic device to charge / power supply
2, Press the switch to start charging when your device connected with EPOWER; If you unplug the cable, auto-sleep will start in one minute.
3, Five lights will flashcircularly during the charging by EPOWER and all lights will keep bright when your device is full-charged
4, During the charging for your device, LED lights indicate the balance power of built-in battery of EPOWER. Four lights indicate *0% balance, three lights indicate *0% balance, two lights indicate *0% balance and one light indicates *0% balance. The built-in battery is empty whenall LED lights start to flash

5, Press the switch three seconds to start If you want to use LED for illumination and select the status ( light, burst flashing, SOS, close) by pressing the switch to transform.

6, Store the product in a cool and dry place and away direct sunlight.

4.Jump start *2V vehicle Instruction:

1. Make sure that the number of indicators is not less than 3 ones.

2. Connect the RED clamp to the vehicle's battery positive (+) terminal and connect the BALCK clamp to the vehicle's battery negative (-) terminal.

3. Plug the cord of jumper cable into the jump start socket.

4. Start the vehicle.

5. When the vehicle is started, remove the jumper cable from EPOWER and disconnect RED and BALCK clamps to the vehicle battery.

6. Leave the vehicle's engine running.

5.Product Highlights:
The smallest and lightestjump starter with patented technology in the current market.
Use high power polymer cells, fast charging and low self-discharge, cycles can reach ***0 times.
Support *2V vehicle for emergency start, portable illumination and various mobile phone, PSP, MP3/MP4 Pocket PC PDA, notebook as well as other products charge / power supply;

6.Product photo