タイトルまたは説明

Introduction and structure
Melting furnace and holding furnace are tied together. No smoke furnace itself while melting. Auto constant temp control unit is available. Widely used in the field of brass,copper alloy products.
Both furnace connect through bottom, raw material melted down, liquid can be flowed to holding furnace chamber after component of liquid met special requirement. We this design structure can reduce smok,loss of zinc because of oxidizing. Energy consumption is less.
The two main frequency cored induction furnace  are composed by furnace body, inductor,cabinet, the inductor is installed under furnace body, include iron core, copper loop, coil, water jacket and so on.

1   **0kw melting furnace + *5kw holding furnace 

Specification:                                                              Specification:

Model: 5*0                                                                  Model: **0

Power: **0kw                                                             Power: *5kw

Rated voltage: **0v                                                     Rated voltage: **0v

Melting rate: 5*0kg/h                                                 Output stream: 2 (one direction, 6ton/day)                                                                                                              

Working frequency: *0hz                                                                     the other 2 outlet is considered

Capacity: 1.6ton                                                          working frequency: *0hz

Inductor:  U type, single coil                                      capacity: 2.5ton

Quantity: 1 set                                                             inductor: U type, single coil

 Introduction and structure

The casting machine is composed  by pedestal ,electronic motor, speed reducer, gears, pulling roller, screw  down device, speed control system.

2   Die casting machine     

Specification:

Model: SYO*70

Speed: **0.**5m/s

Casting diameter: ***0mm

Quantity: 2 set 

Introduction and structure

This cutting machine is suitable for fix length cutting(rod, pipe). It is made up of pneumatic system. Automatic cutting and unloading is available.The saw is welded with hard alloy, can bear high temp. The saw can move along the guide rail. After finish cutting, the saw will be pushed back by air cylinder.

3 Pneumatic cutting machine  

Specification:

Model: Q70

Cutting size: Φ***0mm

Speed: *0s/pcs

Power: 3kw

Working frequency: *0hz

Driver: pneumatic unit

Air pressure: **1 Mpa

Quantity: 2 set