タイトルまたは説明

Hair removal heater
1.automatic temperature control
2.CE certificate
3.ABS, AS material Aluminum pot
4.melting different wax
This type of hair removal heater can be used for melting four pieces wax together, both in Depilatory wax and Paraffin wax
Appliance using steps for depilation
1.Put can wax into heater tank and cover the lid.
2.Plug in and circumroate the knob to adjust temperature, the pilot lamp lights and the heater works.
3.Plug out when the wax is melted for treatment.
4.Clean the skin of treating part before depilation.
5.Apply the melted wax on skin equably along hair grown direction, with a Cuticle stick.
6.Then affix depilatory paper to waxed skin and clap to make them clingy.
7.Rip depilatory paper quickly reverse the hair grown direction.
8.Clean up all residual wax with appropriative wax cleanser.
Operation:
1.Before use, make sure the skin is absolutely clean.
2.Insert the wax into the wax machine.
3.Plug the wax machine into the main machine, connect the main power and turn on the power.
4.Heat the wax for about ****0min, then begin to use.
5.Move the products to the direction that the hair grows and cover the area of ****8 square centimeters. Make sure suitable the temperature of wax treatment. if the wax is too hot ,wait for a while then begin the operation or place the wax on the hair removal paper to use.
6.Use the paper band on the treatment area, use hand to press down the hair grows.
7.Tear off the hair-removal paper to the reverse direction that the hair grows.
8.After hair removal use the cleanser for hair-removal to clean.
9.After cleaning, Use the moisture without fragrance to do massage.
Specification:
Model No IW****7
Carton size *2**6**2cm
Voltage **0/**0V
Frequency *0~*0Hz
Power **0W
G.W. 2.5kg