タイトルまたは説明

When filling the hot water bottle, DO NOT USE BOILING WATER. This will cause damage to the rubber and can considerably shorten the life of the hot water bottle.

Fill only to maximum Two-Thirds capacity. Do not overfill as this might cause the bottle to burst.

When filling hold the bottle by the neck in an upright position and fill slowly to avoid the hot water splashing back.

Expel any air from the bottle by carefully lowering onto a flat surface until water appears at the opening,

Screw the stopper tight enough to ensure that there is no leakage, finger tight should be adequate. Do not over tighten as this will damage the seal.

Finally, make sure the funnel is empty.  If there is a possibility that prolonged contact with the skin could occur, an adequate cover should be used to prevent burns.  Under no circumstance should the hot water bottle be used as a cushion and be sat on.

Before use allow *0 minutes for the bottle to reach maximum temperature.

When not in use, remove stopper and empty contents, store in a cool, dry, dark place. Prevent exposure to sunlight.

Do not place anything on top of the bottle during storage.

Prevent contact with hot surfaces.

Check the bottle and stopper for wear and damage prior to use