JS Cement based Waterproof coating

タイトルまたは説明

Brief introduction：

In recent years the building waterproof coating is a large category in the rapid development. It is composed of an organic polymer emulsion and cement and various organic pigments and compounded with a two-component waterproof coating. It is a new building material with both organic materials with high flexibility and inorganic materials with good durability .High strength and tough waterproof layer formed after the film.

Main features：

1.Take water as the dispersion medium,non-  toxic,harmless to the environment.Its a kind of environmental friendly product.
2.Paint films have compare the high elasticity and the tensile strength,water 
   resistant,the weathering resistance is good.
3.Can be directly used in many kinds of basic plane,no matter in the moist base or dry.
4.Easy to operate. There is no limits for basic unit moisture. Construction time could be reduced.
5.Any color auxiliary can be added to this product to achieve the effect of waterproofing and decoration.nce is good.

Packing：

1.Tow-in-one:
â‘ *0kg/plastic cask
â‘¡*0kg/plastic cask

2.Single component:
â‘ *0kg/plastic cask
â‘¡*0kg/plastic cask

3.Double component:
*0kg(liquid)/cask**0kg/Sack(powder)

Where to use：

In new and cold construction,basement,roof,toilet,ect.And the waterproof,corrosion prevention in metal pipeline. moist or dry bricks and stones, the mortar,the concretes,the metal,the lumber,each kind of hear insulating layer base.any waterproofing and repairs constructions.

How to use：

1.Clean the surface, surface requires a firm and flat, with strength, not hollowing loose, sand and other phenomena, the yin-yang angle should be put into a circular, with a water outlet phenomenon should do first leakage treatment.

2.Use the blender stir and slowly add the powder, stirring for 5 minutes, stirring until the feed does not contain aggregate, with good material should be used up within 2 hours, otherwise will influence the construction of elevated viscosity. (Powder material can be directly used to replace ordinary Portland cement)

Coating weight ratio method according to the product packaging dimension scale ingredients, water adding amount can be adjusted properly, to adjust the coating station consistency, to meet the different parts of the construction elevation and plane.

Embedded in the groove sealing material, in the corner, pipe root and other details shall many times (**5 times of brushing), underground engineering to paving a layer of reinforcement material

 Each layer of brushing time interval of 8 hours, the winter should be extended, each over the film in0.**0.5mm as well, should not be over too thick, inside construction should not add water or less water as well, in order to avoid coating flows.

 3.Apply construction, primary processing, primer, additional layer construction, surface coating and protection layer

 4.Using a brush or roller brush paint brush evenly on the grass-roots , should be painted horizontal and vertical cross, interval of 4 hours or more. General primer two, surface coating two, additional layer using ****0grams / square meters of non-woven fabrics, each square was 3kg, thickness of 1.5mm, if have special structural requirements may account for the increased surface besmear brushes number.

Matters needing attention

1.Ingredients to accurate metering, mixing evenly, use should not add water.

2.Construction of the temperature should be above 0 degree, under negative temperature construction shall take the necessary freezing measures

3,Waterproof coating is now with the current use, and used it within four hours.