Lift Control Card (ARL-300)

タイトルまたは説明

ARL***0 is a lift control card that can work in One, Two Speed, VVVF and Hydraulic systems with any command type up to *4 floors. Here are its features: - All system parameters can be adjusted by using 4 s and an LCD placed on the card; - Can be used with any command type up to *4 floors; - Can be used at one speed, two speed, speed controlled and hydraulic lifts without any extra parts. System can be selected from the menu; - Can be used in group operation up to 4 elevators. All panels in the group are same and no extra panel is needed; - Only two cables are needed for group communication; - Easily installed and safe detected shaft information gathering system; - An error code with its explanation is displayed on the LCD at an abnormal condition. (Ex. H1: Door can not locked) ; - At normal condition the lift can be monitored by messages on the LCD. (Waits for calls, high speed, low speed, inspection) ; - Each floor can be named by an alphanumeric character (L, P, E, F, H, b, o, 0, 1, 2, 3. . . ) ; - *-segment and signalization outputs are short-circuiting protected. In a short circuit case the concerned output is shut down until problem is removed and a message stating which output is short-circuited is displayed on the LCD. (D segment short-circuited) ; - Only *5 cables are enough for system to work by using serial car connection (FX_SERI) which reduces labor and cable costs; - Emergency rescue by 2 pieces of *2V batteries. Arl-SARJ Charge Card controls and charges the battery if necessary; - Connection cards, which are used instead of panel terminals, are supplied with flexible parallel connection cables thereby saving extra connection terminals on control panel; - Integrated door bridging safety relays for door pre-opening and re-leveling; - Integrated motor-phase protection relay; - Integrated automatic door control s and outputs; - Binary or grey code outputs for LCDs and Dot Matrix Displays; - EN *1 compatible.