タイトルまたは説明

Our magnesium alloy plate and the characteristics of the slab is:

- good raw material purification, less impurity, corrosion resistance, resistance to raise.

- was fully broken, grain size, good shape.

- implement cross the reversing rolling production process, to eliminate all the members of the opposite sex.

- with small plate, rolling roll, high utilization rate

Magnesium alloy machining performance is introduced:

Magnesium alloy cutting the amount of power consumption per unit volume, is lower than other common metal.

Under several typical cutting speed, all kinds of metal magnesium relative to power consumption as shown in chart a magnesium (assuming power consumption for 1)

Metal relative power consumption coarse car when cutting speed (m/min) using ***0 mm drill bit drilling speed (m/min)

Magnesium alloy 1.0 up to ***0, ******0

Aluminum alloy 1.8 *****0, *****0

Cast iron 3.5 **********0

Low carbon steel ***********0 6.3

Nickel alloy *0.0 *********0

Because of magnesium alloy with good thermal conductivity, small cutting force, so the process of cooling speed, the knives' service life is long, sticky knife quantity is little, which can reduce the tooling cost, shorten the replacement tools needed for the downtime. Because magnesium free-cutting, the chip breaking performance is very good, usually only after a finishing can reach the required final surface finish.

Magnesium alloy sheet machining, used as vibration components, its service life is 5 times of aluminum.