Multi Coin Acceptor

タイトルまたは説明

~Specification
Coin Diameter： *5mm**2mm          Atmospheric Pressure： *6Kpa—**6Kpa        Signal Output：pulse     
Coin Thickness：1.2mm*3mm          Accuracy Rate of Identification：*9.5%        Speed：≤0.6s
Working Voltage： DC **2V ±*0%    Working Humidity：≤*5%                      Working Current： *5mA ±5%
Connection and Switches

Note: The number on code indicate rank order for coins. H1 is for type 1, H2 is for type 2.
　　　　Free to use this product after Parameter Setting and Sampling. AP Mode is optional function.
Parameter Setting
Hold on ADD" and "MINUS" simultaneously for seconds. Letter "A" shows up from the display.
Hold on "SET" for seconds. Letter "E" shows up. Use "ADD" and "MINUS" to adjust number for TYPES of coins. Next, hold on the "SET" for seconds.
"H1" shows up. Use "ADD" and "MINUS" to adjust number as ****0 for sampling for type 1.
Next, hold on the "SET" for seconds.
"P1" shows up. Use "ADD" and "MINUS" to adjust number for output's signals/pulses for type 1.
Next, hold on the "SET" for seconds. The maximum pulse is *0.
"F1" shows up. Use "ADD" and "MINUS" to adjust accuracy. Next, hold on the "SET" for seconds. The value is from 1 to *0, and 1 is the most accurate. Normally, ***0 will be fine.
The first kind of coin has been programmed so far.
Please repeat No.*- No.5 until Letter "A" shows up again. Hold on "SET" for seconds.
Letter "E" shows up again. Please power off and on. Parameter is saved.
Tip: Free to hold on SET for seconds for skipping if revising parameter on code is not needed.
Sampling
Hold on "SET" for seconds, and "A1" shows up from display.
Please insert coins of TYPE 1 into coin entry until "A1" shows up again.
Please repeat No.1 and No.2 until all types of coins has been sampled.
The system will restart automatically after finished.
Tip: Free to power off if these is no more types of coin for sampling.
AP Mode
Free to control output pluse ratios by using AP Mode.
Free to adjust ***0 pluses to output 1 signal based on P. EX: 3 pluses output 1 signal.
Please hold on "SET" and "ADD" simultaneously for seconds, then hold on the "SET" for seconds.
AP shows up. Please use "ADD" and "MINUS" to adjust number.
The default value of AP mode is 1.