离岸价格
Get Latest Price3 ~ 5 USD / Piece
|200 Piece Minimum Order
国:
China
モデル番号:
AK-GY01
离岸价格:
3 ~ 5 USD / Piece Get Latest Price
ロケーション:
Guangdong China
最低注文量の価格:
3 per Piece
最低注文量:
200 Piece
パッケージの詳細:
1*remote control switch module
納期:
3-15Days
供給能力:
50000 Piece per Week
支払いタイプ:
Other, T/T
製品グループ :
連絡先担当者 Phoebe
Shangxue Science Park Bantian Town, Shenzhen, Guangdong
|
Package Contents: 1*remote control switch module Technical parameters: 1, working voltage: DC4.5~*5V 2, level output: 3V high, no 0V low 3, Induction angle: **0 degrees 4, static current: < *0 μA 5, sensing range: 0.5~8 m 6, trigger delay: adjustable range of ****0 seconds 7, trigger modes: h: repeat/L: do non-repetition 8, dimensions: PCB dimensions: *2**4**5mm, screw pitch *8mm, screw aperture 2mm The module has three output pin, marked "+" is the positive supply to the "-" to, marked "OUT" is the output pin was activity output 3V high, no output 0V low, figure lower right corner of a detection method to switch the short route, intermediate, and H are connected for the repeat mode, the detection area was the module has been output, this model is generally referred to as the level of output, intermediate and L connected to the non-repeating patterns, which modes, even if the detection area was activity module will automatically stop the output period of time (block delay) and then detected, this mode is generally used to call the pulse output. **5 yellow potentiometer module action output delay adjustments, is to check the time delay of several seconds of high signal output to the body, and the adjustment range of 3 seconds to *0 seconds, clockwise delay longer, the factory default 5 seconds or so. Module blocking delay time by C6 decision (default is **2, The blockades time of 0.3 seconds), if you need a light control function, you can connect a photoresistor in the CDS position, photoresistors selected common species of the market can. The module uses low-power regulator device ***3A*1, can guarantee to provide a stable operating voltage, to ensure that the modules can work in a wide voltage. Note: 1, sensor module after power initialization time of a minute or so in the meantime module interval to output from 0 to 3 times to enter standby mode after one minute. 2, Should try to avoid the lights and other sources of interference close to direct the module surface of the lens, in order to avoid the introduction of the interference signal malfunction; use of the environment to avoid the flow of wind, the wind will interfere with the sensor. 3, Sensor module with dual probes, probe of the window is rectangular, dual (A, $ B $) at the direction of the longer ends when the body from left to right or from right to left through the infrared spectrum to reach the dual time, distance, there is difference, the greater the difference, the more sensitive the sensor, when the human body is walking toward the probe from the front or top to bottom or from bottom to top on the direction of the dual detection distance of less than infrared spectroscopy, no difference The value of the sensor insensitive or do not work; when installing the sensor, the direction of the probe pairs in the direction and human activities as far as possible parallel, to ensure that the probe has been the human body after dual sensor. The circular lens in order to increase the sensing range of angles, this module also makes the probes on all four sides induction, but the scope of the right and left sides in both directions is still higher than the upper and lower induction sensitivity, the installation still have as far as possible according to the above requirements. |
| 国: | China |
| モデル番号: | AK-GY01 |
| 离岸价格: | 3 ~ 5 / Piece Get Latest Price |
| ロケーション: | Guangdong China |
| 最低注文量の価格: | 3 per Piece |
| 最低注文量: | 200 Piece |
| パッケージの詳細: | 1*remote control switch module |
| 納期: | 3-15Days |
| 供給能力: | 50000 Piece per Week |
| 支払いタイプ: | Other, T/T |
| 製品グループ : | Wireless RF remote control switch |
