タイトルまたは説明
Sleeve Anchors With Anti-Spin For Heavy-Duty
Fixings. Hexagon Bolt type.
MEASURES
M6 - M*0
LENGHT mm / inches
*5 mm. - **0 mm.
MATERIAL
Carbon steel with zinc
plated
Before placing the anchor checks to be made to ensure the strength
class of the
concrete is not lower than that to which the characteristic loads
apply
• The concrete to be well compacted, e.g. without significant
voids
• Base material temperatures during installation: *5 / + *0 ºC (*0
ºC in a short
period of time)
• Anchors to be installed ensuring not less than the
specified embedment depth,
The edge distance and spacing to be kept to the specified values,
no minus
tolerances to be allowed
• Drill to the minimum depth and diameter specified, maintaining
perpendicular to
the surface of the base material. Fixture holes themselves can be
used as
template.
• When drilling holes, care to be taken not to damage
reinforcement in close
proximity to the hole position. Action to be taken in the event
that drilling is
aborted, e.g. due to encountering reinforcement. It is recommended
to either
install the anchors immediately beside the aborted drill
hole, provide that
anchoring depth is increased by the depth of the aborted
drill hole, or make a
new drilling at a minimum distance away of two the depth of the
aborted hole.
Alternatively, a smaller distance may be chosen, provided the
aborted drill hole is
filled with high strength mortar. However, unless the aborted drill
hole is filled
with mortar, it is not permissible a shear or oblique tension load
in the direction of
the aborted hole.
• Thoroughly clean hole from dust and drilling fragments.
• For holes to be subjected to temperatures below 0 ºC, measures to
be taken to
avoid the ingress of water into the hole and subsequent risk of
local cracking of
the concrete due to ice expansion.
• To introduce the anchor into the hole up to the embedment
depth through the
fixture, a hammer can be use to assure this depth. Do not apply any
intermediate
lay between the fixture and the washer (sealant, etc.). Apply the
specified torque
with a torque wrench.
• In case of holes with diameters higher than specified,
use washers of bigger
diameter and thickness, but in this case it is not assured a
correct distribution of
shear loads amongst all the anchors of a same group. The shear load
will be
applied on those anchors with the correct diameter on the fixture.
| 国: |
China |
| モデル番号: |
CH
|
| 离岸价格: |
（交渉可能）
Get Latest Price
|
| ロケーション: |
cixi of Ningbo |
| 最低注文量の価格: |
- |
| 最低注文量: |
1 Pallet |
| パッケージの詳細: |
boxes then cartons, on pallets |
| 納期: |
2-3 months/plt |
| 供給能力: |
100000000 Piece per Month |
| 支払いタイプ: |
T/T, L/C |
| 製品グループ : |
sleeve anchor
|
