タイトルまたは説明

 AE*0 bark control collar Main Features

1.Lightest bark collar , great for even the smallest dogs

2 .7 intensity levels for a wide variety of dispositions

3.Adjustable 5 sensitivity levels , On/Off switch

4.Waterproof design

5.Easy testing method to check the Bark Control Collar

6.Multi-color LED indication

7.Selective contact points to match the dogs coat type

8.Low power consumption

9.Unit size: L*W*H= *1**7**0 MM

*0.Powered by *-Volt battery

Operation Guide:

1.Place battery correctly

Open the metal Battery Door by a coin. Insert *-Volt battery and close the Battery Door . Please note

correct direction of the battery : the + polarity face to metal Battery Door .

When you do not use the bark collar , turn the Switch to OFF position to save power .

Battery life is dependent on the number of corrections your dog receives, but on average the life

should be 3 months .

2.Test collar

Scratch the rough surface of the Bark Control Collar by a finger nail or pen . The green light on the

top of collar turns to a blinking green light . Then repeat the same process if you want to test it again . .

3.Adjust Sensitivity Level

. Begin with the setting in low sensitivity level . If the unit does not emit a correction when the dog

barks, turn the Switch clockwise to increase the sensitivity level .

4.Fit the Bark Control Collar

Place the collar strap in the middle of the dogs neck. The Collar should be on the underside of his

neck althoughon some dogs necks the collar will naturally seek a slightly off-center position.

Tighten the buckle by holding it with two fingers as you pull the strap snug. The collar must be put on

a dog quite snugly to ensure consistent contact and reliable stimulation.

Do not put any fingers under the strap as you tighten it. .

5. Safety protection mode

To protect the pet from the excessive stimulation , The anti bark collar has safety protection . If the

anti bark collar has been activated for more than 5 times continuously , it will stop shock for *0

seconds . While the Red and Green Led will flash in turn . *0 seconds later , the anti bark collar will

return to sleep mode.

FAQ:

After I use a bark collar , My dog will stop barking altogether ?

This is highly unlikely , especially if you follow the advice in the Training Manual. Barking is a

natural behavior and a needed outlet for a dog .So they are very good at learning what situations they

are allowed to bark

.

Is it possible that my dog learn to not bark only when the bark collar is on ?

Yes . This is possible . This is best accomplished by placing the bark collar on your dog only in those

situations in which you never want him to bark . Also, never place the bark collar on our dog in those

situations in which you want him to bark .

I have more than one dog , but only one dog with a barking problem and I keep both dogs

together. Is this going to cause any problems between my two dogs ?

It should not be a problem, especially if you follow the procedures described in Training a dog with

bark collar.

Packing :

Blister and color card *0Pcs/Carton Carton size: *2X*9X*0CM

Packing List:

1*Bark collar

1*TUP Strap

1*Test Neon Light

1*4LR*4 6V Battery

1*Spanner for Probes

2*Long Probes