T-ULTRAPOLY
MINERAL-PY membranes are made by saturating
and coating a robust reinforcement of non-woven
polyester **0 gm/m2, **0 gm/m2. It is coated
with a blend of thermoplastic modified bitumen compound [APP
Atactic poly propylene] used distilled Bitumen, additives. This mix
is produced with excess care, controlled Quality to ensure membrane
stability characteristics at high temperature, and its flexibility
at low temperature. T-ULTRAPOLY
MINERAL-PY membranes are easy to apply by
torch, impermeable to water & retain good and weather
resistance properties.
FEATURES:
*Robust design product to meet all requirements.
*Good resistance to tear and puncture.
*Superior bonding [adhesion] with substrates and seams.
*Industrial product, heavy duty application.
SURFACE FINISH & SIZE OF ROLL:
Both top & bottom covered by P.E Thin films printed
Also SAND & SLATED finishes on exposed side to protect
The membrane from UV rays .The slate finish available
With various colors on customer choice .The membranes are
Produced thickness 3mm,
4mm and 5mm with the
standard length *0 meter and standard
width 1 meterwidely.
USES
T-ULTRAPOLY
MINERAL-PY membranes are suitable for
general roofing and waterproofing application and it can be used in
single or multi-layer system. Suitable on low slope concrete roof,
balconies, multi-story car parks, for lining sewerage canals Sub
level structures and any cement, concrete flat substrate that needs
waterproofing.
APPLICATION
The waterproofing surface must be thoroughly clean and level prior
to membrane laying work at the site, and free from loose particles,
stones, steel nails, oil, grease, dust and any damaging materials
present on substrate. A coat of TAJ PRIMER is then applied to the
concrete surface at ******0 gm/m2 rate.
Applied primer should be dried well before fixing the membrane.
Membranes are fixed by torch welding called Torch on Application.
The membrane rolls are to be kept ready near the open area in which
they are going to be laid, the rolls are laid, So that next
overlaps the first membrane by *0 cm along the side lap, the
membrane is then rolled back. They are unrolled once again while
heating the underside sufficiently to surface melting .End laps
min.*5 cm .Avoid uneven torching and excessive. The lap joint area
should be heated from top to produce thin molten bitumen at the
seam, which is then smoothened with trowel ensuring properly welded
joint.
EXPOSED ROOFING
For exposed application use TAJ MINERAL
MEMBRANES. These are produced with a top layer of natural
flat slate flakes. The membrane possess selvedge *0 cm covered by
release paper or fine sand .This is to forming lap joints end of
roll joints are made by scrapping of *5 cm of flakes.
TOOLS
Gas, cylinder and gas torch for welding, knife for trimming, a
trowel with round tip, marking aids and gloves.
