thread locker

タイトルまたは説明

**1 Thread locker High strength and low viscosity thread locker ,it applied to the permanently locking and sealing of the thread below M*6. Against the rust of the thread. Used on cylinder block, rocker arm studs, ring gear bolts, frame bolts, shock absorber bolts. **2 Thread locker Low Strength, Thixotropic viscosity, against rust, easy disassembly Used in the most metal surfaces. Applied for the locking & sealing of M*- M*2 thread and the fastener diameter of 1/4 “ (6mm) or smaller. **2 Thread locker Medium strength, thixotropic, lubricating, easy disassembly. Applied to the locking and sealing of M*-M*0 thread. Used on valve cover bolts, water pump and oil pan bolts, drive shaft bolts, rocker arm adjustment nuts, carburetor studs and axle cover screws, etc.. **3 Thread locker Anti machines oil, medium strength, fast curing, easy to disassemble and easy to dissolve in oil. Used on the inert surface, can be worked on the surface of slight oil.Applied to the locking and sealing of the thread below M*0. **2 Thread locker Excellent chemical resistence, thixotropic viscosity, against rust and anti-corrosive. Permanent studlock, high strength, applied to the thread below M*0 and the engine bowl shape thread. Used on assembly with air tools, cylinder block bolts, ring gear bolts and thansmission shaft bolts. **2 Thread locker Temperature resistence to **0℃, and high strength .Fast curing on most surface(include the uncleaned fasteners)Used on the diameter below M*6 and the cyliner blots studs.Need tools and heating when take down. Camshaft sprocker bolts, crankshaft bolts, idler bearing, press fit filler tubes, ring gear and shock bolts. **7 Thread locker High strength, high viscosity, chemical resistance, against rust and anti-corrosive. For permanent locking and sealing of thread below M*6. Need tools and heating when take down. **0 Thread locker High strength, low viscosity with high permeability and fast curing. Used on the assembled M2 to M*2 thread locking and sealing, the sealing of the flaws,lossen and dits of the castings(below 0.*0mm). Need tools and heating when take down.