タイトルまたは説明

0.6/1KV COPPER/XLPE/STA/PVC power cable

Cable Selection

It is essential that the type of cable ordered is suitable for its intended use. Cable choice will be based on a whole range of factors including installation specifications, relevant local regulations and the performance of appropriate cable types. It is therefore impossible to provide a conclusive guide to cable selection and we would advise you to contact us for our specialist advice on suitable designs to meet you specific cable needs.

 

Conductors

Conductors shall be of Copper or Aluminium, circular standed(Non-compacted or Compacted) or Shaped, Class 2 to IEC ****8, BS EN ****8. For smaller sizes, a solid circular conductor, Class 1 as per IEC ****8, BS EN ****8 can also be supplied upon request.

 

Insulation

• XLPE material and thickness shall be as per IEC ****2 or BS ***7 rated for *0°C continuous operation.
• PVC material and thickness shall be as per IEC ****2 or BS ***6. PVC insulation Material-Type A as per IEC ****2 or TI1 as per BS EN ****3.
• PVC insulation as per SASO ***4 rated for *5°C continuous operation is also available on request.

Assembly

Two, Three or Four insulated conductors are laid-up together with non-hygroscopic fillers compatible with the insulation material and the assembly is bedded with an extruded layer of PVC. In case of non-armoured cables, this layer may be omitted if the outer shape of the cable remains practically circular.
 

Armour

Galvanized Steel Wires applied helically over the bedding as per IEC ****2 or as per BS ***7, BS ***6. (Single core cables shall be Aluminium wire armoured) Double Steel Tapes applied helically over the bedding of multi-core cables as per IEC ****2. 
 

Outer Sheath

Outer sheath will be extruded PVC type ST2 as per IEC ******1, Type 9 as per BS ***5. Special type of PVC sheathing material such as fire retardant PVC, anti-termite and anti-rodent PVC, ultraviolet PVC, Oil resistant PVC, etc. are available on request also other special sheathing materials such as LLDPE, MDPE, HDPE, LSF, CPE etc are available. 
 

Fire Performance of Cable Sheaths

Cables can be supplied with special flame retardant PVC outer sheath to comply with the flame test requirements of IEC *********2, IEC *********3 and IEC *********4, can also supply cables with Low Smoke Halogen Free (LSHF) material according to IEC ******1, BS ***1, BS ***4 or other equivalent standards.