YELANGU 3 Axis Gimbal G2 Professional Photography Equipment Camera Stabilizer for DSLR Video Camera Camcorders

1.Accemble the kit

2.Accemble the tuning stand

3.Put the gimbal onto the gimbal tuning stand

4.Balance your camera

5.Mount on the battery pack

6.Plug on the power connector and Joystick connector

7.Remove the gimbal tuning stand

8.Power on your gimbal,rady to use.



How to balance and adjust G2 centre of gravity

Step 1:Horizontal tilt/Vertical tilt

The centre of gravity needs to be balance before steadycam G2 Plus can be used.The centre of gravity can be adjusted by moving the camera around and certain mounting points.Little movements are all that are needed.Proper balancing is essential to correct operation of Steadycam G2 Plus gimbal.When the gimbal is able to never return to the same position after being gently tapped,balancing is complete.

*First,the camera itself needs to be adjusted forwards/backwards.Work towards making the camera sit level.

*Next,the up/dowm sliders on the pitch assembly need to be adjusted.Camera should roll without stopping in same position.



Step 2: Roll balance

The roll needs to be adjusted next.There are two options to adjust roll.It can be adjust where the camera mounts or the back mounts on the roll poll.Sometimes both need adjustment to get correct balance.We prefer that to move camera mount to adjust the camera mount to adjust the camera balance.Move assembly left/right to get balance correct on either camera side or rear mounts.Pay attention to keep everything lined up horizontally.



Verify the balance by moving your roll sxis to several locations.If roll stays and does not fall to either side,your roll is balanced.



Step 3: Pan balance

The pan balance is the last axis to balance for the Steadycam G2 Plus.The pan balance will ensure that the entire mass below the pan motor is balanced on the central axis line of the pan motor.The simplest way to check for your pan axis to be lanced is to tilt the gimbal is the stand and see which way the pan axis swings.



WAENING BEFORE USE

*Please save the profile before you change any settings 

*We strongly recommend that you do not turn on your gimbal if your camera is not mounted.

*Althought the Steadycam G2 is tested with a camera before shipping,it does not come pre-turned or balanced for your specific camera setup.

*Costomers will be respomsible for tuning and balancing their camera.We can provide enample profiles upon request.The default test camera is 5D2 and the default settings is base on the camera datas.

NEVER DO THIS:

1.Never turn on the gimbal without plug on Joystick

2.Never turn on the gimbal when it's on the stand

3.Never turn off the gimbal during use the inverted mode

4.Never change the settings before you read this instruction