タイトルまたは説明

• Item Type:Other
• Item Height:5 cm
• Brand Name:Aftermarket
• Model Name:**********0 **********0 **********0 **********1 ******0W**0
• Item Width:*5 inch
• Special Features:Belt Tensioner For TOYOTA
• Item Length:*0 inch
• Material Type:Flat Steel
• Item Weight:1.2 kg
• FEBI:****6

How to Tell if a Timing Belt Tensioner Is Bad

Replacing a timing belt is one of those things that scares most car owners because it is an in depth job and usually quite expensive when done at a shop. More often than not, it is actually the tensioner that goes bad, not always the belt (unless it is really old). most of the time a belt will break due to a seized pulley or bad tensioner allowing it to contact the timing cover.

Steps 1

Listen. A bad tensioner will usually be accompanied by noise. This noise could be some type of squealing or rattling coming from the timing cover area. also when your timing belt is loose it will cause some drivability issues usually under high load or high rpm. If your timing belt is not properly tensioned it will not keep the valves timed properly to the lower end and this will cause misfires, loss of power, bucking, and could even cause a no start condition.

Steps 2

If the car runs, then stand on the side of the car where the pulleys are and try to distinguish where the noise is coming from.If you hear the noise coming from the front of the engine and its not coming from your accessories. Most often the noise will be the belt flapping around due to the loss of tension.

Steps 3

If the car doesn't run and you are going to be the one doing the work, then remove your front accessories enough to get to the front cover.Once done, remove the front cover and check to see how loose the belt is. There should be a little slack on the opposite side of the tensioner but not much.

Steps 4

With the cover off, check for the free movement of all the idler pulleys and the tension itself.It will be very apparent if something is broken.

Steps 5

While you are in there, it is smart to just get a timing belt kit and replace all the pulleys and the belt.

Steps 6

Make sure that you line up all your marks and set the proper tension on the belt.