ISO Fingerprin

タイトルまたは説明

As an OEM module of fingerprint identification, it can meet the requirements of fingerprint identification system based on international standard exchange format (A)NSI/ISO very easily. Or USB communication interface for the UART, it as a work from the device, the host will send commands to control it.
Main functions: support standard: ansi**8 iso******2, fingerprint capacity: ***0 fingerprints (response time is less than 2.0 seconds), template size: ***4 bytes, recognize patterns: 1: n logo or 1:1 verification, automatic learning function, the fingerprint template, speaking, reading and writing features, fingerprint image read and write functions, is the uart and usb communication interface.
Fingerprint image characteristics: resolution: **0 dpi; Gray: 8, **6; Pixel matrix: **8 * **8  **6 * **8
Application: fingerprint access control; Fingerprint attendance; Fingerprint lock, fingerprint safe; Fingerprint POS terminals。
 
 
(2) technical parameters
The Item Parameters
Fingerprint capacity Default: ***0
False admission rate < 0.**1 %
Rejection rate < 0.1 %
Comparison method 1:N comparison, 1:1 comparison
The length of fingerprint characteristic value is ***4 Bytes
Response time fingerprint pretreatment < 0.6s
1:N comparison (full ***0 fingerprints) < 2.0s
Communication mode USB2.0 or UART (3.3 v-ttl logic)
Serial port communication starting bit =1, stop bit =1, parity check = none,
Baud: ***0/****0/****0/****0/*****0/*****0/*****0/*****0
The Default is *****0 BPS
Power supply voltage: DC3.3 v*6v
Working current < *0mA
Static current <= *0uA
Working environment temperature: - *0 ℃ ~ *0 ℃
Working humidity: *0% ~ *0%
 
 
 
 
 The pin of serial port 5Pin interface is defined as follows:
 
The pin name is type energy description
VCC in power supply terminal.
2 TX In/Outt module serial port sender
RX In/Out module serial port receiver
GND - internal connection to power source.
5 dangling
The pin of USB 4Pin interface is defined as follows:
The pin name is type energy description
VCC in power supply terminal. (5 v)
2 D+ In/Out USB signal line
3 D- In/Out USB signal line
GND - internal connection to power source.
5 dangling
Note: in the type column means to module, and out means output from module
(1) communication agreement
3.1 communication processing