Motorcycle EFI tester and cleaner(ECM-2C)

Description

 II,Specifications&Functions. Fuel Injector test and cleaner mainly apply to fuel injector testing ,cleaning and quality analyse. 1.To test and analyse the injecting state 2.To test the dribbling of injector 3.To test the injecting angle and atomizing 4.To test the injecting volume. 5.To test the injector uniformity 6.To test the physical and chemical cleaning of the blocked or trouble injector,ultrasonic cleaning,test cleaning and on-vehicle cleaning. 7.To test the open and close injecting pressure of the injector. 8.Can clean the motorcycle engine without dismantling(should choose matched connector). 9.Can operate the auto static test,dynamic test and selective test with the injecting dribbling,angles,atomizing,uniformity of one or two injectors,can simulate any state of the motorcycle to observe the complete process of injectors *0.Can operate automatically,reversely,and ultrasonic cleaning with one or more injectors at different state,such as high resistor,low resistor,electric voltage and electric current. *1.Can test by count mode and timing mode. *2.If use new type injector,just need to choose the matched connector and replace the O-ring. *3.If adopts to united design of microcomputer skill and intelligent engine,and suppose driving power and specified injecting protection system,ensure to operate the test and clean at any mode such as high resistor,low resistor,electric voltage and electric current. *4.Have powerful,safe and time ultrasonic cleaning system. *5.If uses environmental protective and safe test fluid and cleaning detergent,accords with Montreal Agreement,innocuous,with no peculiar smell,non-voltage and can be reclaimed repeatedly and effective,its innocuous with the operators.