Handling Table

Description

Handling table ï&frac*4;ˆ1ï&frac*4;‰ Initial table 　　a. Accodding to working technology, the profile should be cooled intensively and rapidly once departing the extruder so that to avoid deformation and twist. 　　b. The design that shaft blower cooperate with cooling blower can meet the demand that intensive and rapid cooling. Besides, if it cooperate with water, it will get a better effect. 　　c. Graphite roller can decrease the chance that the friction between roller and profile maximumly. ï&frac*4;ˆ2ï&frac*4;‰Handling table and Extraction belt 　　a. The roller is made of aluminum roller and covered by high temperature felt-belt. 　　b. The table is in raised position during extrusion, and lowing at the end of extrusion by hydraulic cylinder, then put the profile on the extraction table reposefully. 　　c.As customer`s demand, the blowers can be installed on top and bottom of the table in order to cool thoroughly. 　　***** blocks between rollers are not only to protect the profile well, but also to keep producing continuous even without puller. 　　 ï&frac*4;ˆ3ï&frac*4;‰ Cooling table and stretcher table 　　a. The frames are usually made by aluminum profile. 　　b. Every belt is equipped with self tension device in order to avoid the skid happen during conveying. 　　c. Thanks to reasonale width of cooling table, it has enough time for cooling. 　　dï&frac*4;ŽConfiguration of stretcher table: manual or horizontal cylinder type. ï&frac*4;ˆ4ï&frac*4;‰Stretcher 　　a. According to different demand, the movement of the stretcher can be manual and motorised. 　　b. Double hook can fix the stretcher well. Manual fix and hydraulic fix can be chosen. 　　c. The pull can be up to **0t due to strong steel configuration. 　　d. Clamp can rotate that adjust to any situation of profile. ï&frac*4;ˆ5ï&frac*4;‰Batching table and roller table 　　a. The belt convey the profile into roller table after the frame raised by hydraulic cylinder. 　　b. Roller is covered by low temperature belt. 　　c. There are some rubber rollers on the both side of the roller table so that to protect the profile from friction with frame or slip out of the table. ï&frac*4;ˆ6ï&frac*4;‰Finishing saw 　　a. PV roller on both side of the saw can rotate positively and reversely so that to protect the profile from moving blade. 　　b. Cooperate with chip suction device make the table clean and protect profile from chips. ï&frac*4;ˆ7ï&frac*4;‰Saw gauge and Take away belt 　　a. The motorised car can position at any place in certain range. 　　b. For guaranteeing the precision of incision, we add buffer mechanism. 　　c. The belt convey the profile at once after sawing.