Description

The ELM **7 is a multi protocol OBDII Interface, which allows you to talk to your OBDII equipped vehicle using a COM connection for direct input into your PC or Laptop. The ELM **7 interface supports the following Protocols : J***0 PWM (Generally ford vehicles manufactured between ********5) J***0 VPW (GM & some chrysler vehicles) ISO*****2 (TATA, Fiat, Honda, Hyundai, Skoda & Most imports) KWP***0 (Chevrolet and some imports) ISO******4 (CAN) (most ***5 & newer vehicles) Coupled with relevant OBD-II software the ELM **7 interface offers the following features: Read, Display and Clear Engine fault codes (Diagnostic Trouble Codes) - both stored codes and pending codes Switch off Check Engine light (MIL) Full database built-in of generic fault code definitions View live engine sensors such as Engine RPM, Calculated Load Value, Coolant Temperature, Fuel System Status, Vehicle Speed, Short Term Fuel Trim, Long Term Fuel Trim, Intake Manifold Pressure, Timing Advance, Intake Air Temperature, Air Flow Rate, Absolute Throttle Position, Oxygen sensor voltages/associated short term fuel trims, Fuel System status, Fuel Pressure an lots more View the status of all *1 Inspection/Maintenance Monitors (on-board tests, Oxygen Sensor tests) The robust aluminum casing makes this Scantool most suited for users who work with various vehicles with different OBD-II Protocol. Features : Robust casing for rough service use Connects to PC/Laptop via RS**2 (serial) interface ELM**7 compaitable Interpreter MCU for ISO***1, KWP***0, J***0 VPW, J***0 PWM & ISO******4 (CAN) protocols. 5 LED indicator provides status on the state of the scan tool while communicating with the vehicle Power LED OBD Transmit Data (Tx) OBD Receive Data (Rx) USB Transmit Data (Tx) USB Receive Data (Rx) Powered from car battery over OBD2 connector Compatible with a wide range of available OBD2 software Rugged Build and Compact Size : **0 x *0 x *5 mm ( L x W x H)