Fridge Condenser

Description

This wire tube condenser is of compact structure and high efficiency. It can provide good heat dispersion in limited also can replace the fin type condenser which is made of copper tube and aluminum plate, so it can save a lot of production cost for customers. Specifications: 1) Raw material: a) Rolling welded steel tube: 4.*6 ~ 6.*5 x 0.*1 b) Low carbon steel wire: 1.4 ~ 1.6mm c) Bracket: steel plate SPCC thickness 0.6~2.0 d) Base mounting plate: SPCC thickness 0.6~2.0 2) Technical standards: can produce according to clients&#**9; drawing or samples 3) Performance: a) Surface with electrophoresis coating to prevent the corrosion b) Inner cleanness can meet the requirement of R**4a and CFC cooling system c) Can satisfy the cooling capability requirements Structure: Bended or spiral type of wire on tube condenser used at the bottom R**4a cooling system tube inside standard: 1) Residual moisture: ≤*0mg/m² 2) Residual dusty: ≤*0mg/m² 3) Residual mineral oil: ≤7mg/m² 4) Residual chlorine: ≤3mg/m² 5) Sealing density: ≥1.*5MPa Specification of E-coating: 1) Coating thickness: a) Thickness of anodic electrophoresis coating ≥*2Î&frac*4;m b) Thickness of cathodic electrophoresis coating ≥*0Î&frac*4;m 2) Hardness of coating ≥2H 3) Impact of coating: *0cm.kg/cm impact, no crack 4) Adhesion of coating: ≥2 grade 5) Flexibility of coating: around R=3D bend **0 degrees, no crack or no fall off 6) Corrosion resistant (salt spray GB***3) a) Anodic electrophoresis coating ≥*4hrs b) Cathodic electrophoresis coating ≥*6hrs.