Sell automatic edge polisher

Description

Bullnose profiles between *5 and *0 mm. in thickness are obtained by the use of standard plane diamond wheels, and do not require the use of profiled tools. The engagement and disengagement of the abrasives on the edge to be polished is automatic and can be programmed even in the presence of irregular workpieces. Polishing of straight edges has been improved by the introduction of gentle rocking movement of the heads (± 2°). With the use of a special diamond tool light bush hammering type finish (scratching) can be obtainer on straight or bullnose edges up to a maximum thickness of *0 mm. The frontal bar is no longer required. The forward and reverse pressure controlling the abrasives is independent and does not require counter pressure. The conveyor belt slides over an interchangeable wear-resistant stainless steel surface and is fitted with a square cross-section guideway recessed into the work surface near the pressure units thereby avoiding belt displacement during processing operations. The LARA **-S2 is supplied fully assembled, tested under working conditions.