Description

The ECU**2 is one of Kutai&#**9;s best selling Micro Processor based design Digital Genset PLC Control Unit. It offers full engine and generator protections with simple operation and programming without the use of PC connection or software. Features * Micro-Processor Based Design * Easy-to-Read Large LED Display * Compact Size with Vibration Protected * Provides Full Engine & Generator Alarms Signals & Shut Downs * 2 Wire Remote Start & Stop * Front Panel Mounted With Manual, Off & Auto Switch * Provided With Easy-to-Install Auxiliaries, Relays & Fuses * No Need for Magnetic Pick-up to Check Over Speed * Simple Operation & Programming (There is no need for PC connection or software*-all operation can be done directly on ECU**2) * No Battery Power Needed to Maintain Program (Customized settings are auto-saved into memory and will remain even when power is off) Specifications *Power Input Voltage 9~*0 VDC *Sensing Input Voltage *5~**0 VAC , 3 phase 3 wire Frequency *0~*0 Hz *MPU Signal Input Voltage ± 2V to ± *0V Peak Frequency Min. **0 Hz , Max.*0 KHz *Control Signals Current 2.5 Amp with input volts *CT Specifications Burden 2.5VA CT Range Min. *5A / 5A , Max. ***0A / 5A *Power Dissipating Max. 7 Watt *4 Digit 7 Segment Easy-to-Read LED Display - Programmable Display with 3 Phase Volts, Amp & Freq. - Failure Alarms Status - Battery DC Voltage Indicator - Total Engine Operating Hours & Service Alarm - Internal Program Settings & Status *Protection & Alarm Status - Engine Start Failure - Engine Over Speed - MPU Failure - Abnormal Generator Voltage - Low Engine Oil Pressure - Emergency Stop Activated - High Engine Temperature - Generator Over Load - Low Fuel Level - Low DC Voltage