Description

Sell SFP transceiver (**0% Cisco compatibale, support paypal) Features Dual data-rate of **5Mbps /**0Mbps operation MQW FP Structure , ***0nm, PIN LVTTL logic level RX LOS *0km transmission with SMF Standard serial ID information compatible with SFP MSA SFP MSA package with duplex LC connector Very low EMI and excellent ESD protection *3.3V single power supply Operating case temperature: Standard: 0 to **0°C Industrial: **0 to **5°C Applications Switch to Switch interface Switched backplane applications Router/Server interfac ATM SONT/SDH/PDH Standard Compatible with SFP MSA Compatible with IEEE **2.3z Compatible with ANSI specifications for Fibre Channel Compatible with FCC *7 CFR Part *5, Class B Compatible with FDA *1 CFR ***0.*0 and ***0.*1, Class I Compatible with Telcordia GR****-CORE RoHS compliance Description The SFP transceiver is high performance, cost effective module supporting dual data-rate of **5Mbps/**0Mbps and from *0km to *0km transmission distance with SMF. The transceiver consists of two sections: The transmitter section incorporates a FP laser. And the receiver section consists of a PIN photodiode integrated with a trans-impedance preamplifier (TIA). All modules satisfy class I laser safety requirements. The optical output can be disabled by a TTL logic high-level input of Tx Disable. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver. The standard serial ID information compatible with SFP MSA describes the transceiver’s capabilities, standard interfaces, manufacturer and other information. The host equipment can access this information via the *-wire serial CMOS EEPROM protocol. For further information, please refer to SFP Multi-Source Agreement (MSA). The SFP transceivers are compatible with RoHS.