Description

Fearures: 1. Double component, excellent deep hardening performance, has certain adhesive force. It can get better bonding effect when using primary coat. 2. The adhesive will become elastomer after being dried, which has excellent cold and hot resistance performance, weather resistance and anti-ageing performance. 3. For all kinds of metals, most kinds of plastic (epoxy resin, PC, nitrile rubber, ternary ethylenepropylene rubber, ABS etc.) have certain adhesive ***** can have a good adhesive with the ***** has rather excellent sealed force. 4.Widely used to pressurization, waterproofing and anti-high voltage for electronic components, plugboard and other electronic appliances. 5. Typical purpose: The sealing of LED screen, power module and all kinds of electronic products. Application technique: a) Measuring: Weigh A component and B component precisely. b) Mixing: Put component B into container, which has component A, then mix adequately. c) Deaerating: put the mixed liquid into the vacuum cabinet to *****, it is not necessary to take the air out if there is no foam .The deaerating time should be 5~*0 minutes. (If there is no high demand of its electric capability, it is not necessary to be vacuum). d) pouring: Put the defoamed adhesive into the products, which need to be sealed. e) vulcanizing: Put the sealed product in room temperature and let it become hard naturally. After primary hardening, the product may go to the next process, and the completing of hardening needs *4 hours. If you need to speed up , you may heat up accordingly. For example: it will completely harden in *0minsat **0℃. 3. Warning: i. About mixing adhesive: 1. When mix A and B components, you can use machines instead of hands to shorten the time of vulcanizing.But maybe the time is too short to control. (about *0 seconds in ***0turn/min). 2. The surface of the sealed products and the mixing container should be cleaned and dried before using, the *****