Description

Introduction
 
The MODEL***0 inverse multiplexers transmit up 8 Mbps channel over multiple E1 links. They bridge the gap between E1 and E3, allowing bridges and routers to operate at their fastest rates. The MODEL***0 have a built-in *0/**0 Ethernet bridge with VLAN support for LAN-to-LAN applications over 4 E1 links. The MODEL***0 fully meets all of the E1 specifications including G.**3, G.**4. The unit features diagnostic capabilities for performing remote loopback tests 
 

Specification
 
E1 interface
Standard: Comply with ITU-T G.**3
Output tingle displace: accord ITU-TG.**5 advice
Input tingle limit: accord ITU-TG.**3 advice
Output tingle: accord ITU-T G.**3 advice
Frame format: unframed
Interface rate: 2.**8Mbps×4=8.**2Mbps
CRC checkout: no
Port coding: HDB3
Port transmission: 2KM
Port protection: ***0V electromagnetism isolate
Port connector: **0 Ohm(RJ**5) and *5 ohm(BNC double coaxial)

Ethernet port
Interface Types: *0/**0BaseT, full/half duplex
Standards Compliance: IEEE **2.3(support VLAN)
Bit Rate: *0/**0BaseT limited to Max 2.**8 Mbps
Connectors: RJ*5 (*0/**0 Base-T Electrical)
Line code: Manchester Encoding
Connect line: Connect PC with cross-over
           Connect HUB/SWITCH with straight-through

Environment, Power and Dimension
Working temperature: **5 to *0℃
Storage temperature: **0 to *5℃
Humidity: Relative humidity 5% to *5%
Input power: **0VAC or **8VDC
Consumption: 2W

L×W×H: **3mm×**0mm×*4mm
Weight: **0g

Warranty: 5 years
Approvals: FCC, CE, RoHS approvals