Tile Adhesive (C02)

Description

Tile Adhesive Features 1. Well water-protective; Don&#**9;t need to soak the brick and wall to improve work efficiency. 2. Excellent adhesion, both to the wall and to the paint. 3. Maximum protection against leakage caused by moisture saturation; Excellent resistance to corrosion. 4. Excellent elasticity, shrinking-free, no bubbles; 5. Its 3 times working speed than the traditional working way. 6. Convenience to use; Non-toxic Surface preparation All surfaces must be structurally sound, dry, clean and free from movement, oil, grease, wax, curing compounds and any other loose or contaminating materials. Stir and mix Add clean water to a bucket, then slowly add tiles powder to the water. Stir the mix with electrical drill-mixer until a lump-free consistency is achieved. Allow the mix to stand for 3 to 5 minutes. Re-stir then use the tile adhesive. The mixing ratio is *5 kg powder to 7 liters of water. Application Scrape the mixing(thickness is about 3mm) on the surface with scraper; Each scraping area is about 1 square meter; Then use scraper(*0mm**0mm) to cut the surface to rack gear shape. Scrape the mixing(about 3mm) on tile; If there is deep lines or slot, tile adhesive should be added on the back of the tiles. Precautions 1. Make sure vertical and horizontal veracity of the surface before working. 2. The marble must be sticked on the surface within drying time. 3. Must be adjust the marble within adjusting time in order not to effect the intention. 4. Dispose redundant marble adhesive before hardening. 5. The floor should be opened to light foot traffic or grout after *4 hours following the process. 6. Dont apply marble adhesive in temperatures above *0 degree or below 5 degree. 7. Dont allow the adhesive to skin prior to laying the marble. If the adhesive skins, remove and dispose of it, then re-apply fresh adhesive. Remark Main ingredient: Concrete macromolecule polymer Package: *5kg/ craft bag