C channel roll forming machine

Description

C channel **0x*7x*5mm roll forming machine Suitable material of the C channel **0x*7x*5mm roll forming machine : ***-Incoming material: Hot-rolled carbon steel Coil ASTM A**0 G*0 or semi hard. ***-Thickness of incoming material: 1.5—2.5mm ***-Width of incoming material: according to drawing ***-product specification: width **0x*7mm ***-Drawing of profile: please refer the Attached drawing. Main parameters of machine: Manual Decoiler 1 of the C channel **0x*7x*5mm roll forming machine ***-Hand operated type ***-Max outer diameter of coil: ***0mm. ***-Inner diameter of coil: ******0 mm. ***-Max width of coil: **0mm. ***-Capacity: ***0kgs roll forming machine of the C channel **0x*7x*5mm roll forming machine ***-Rollforming station: *3 Nos ***-Material of roller: Gr*5 steel ***-Surface hardness of roller: HRC *5°**7° ***-Diameter of roller shaft: *5mm, material: *5#steel ***-Thickness of side-wall: *0mm ***-Model of bearing: ****0 ***-Thickness of gear: *0mm, material: *5#steel surface high frequency treatment ***-Main motor: 4kw, **0 speed reducer ***-Rollforming speed: *0M/Min ***-equipped with water-cooling device cut-off device of the C channel **0x*7x*5mm roll forming machine ***-Automatic oil-pressure high-speed cutting machine ***-Equipped with cutting mould 1 set ***- Oil station plus wind-cooling device ****-Motor: 4kw Run-out frame of the C channel **0x*7x*5mm roll forming machine ***-Precision welding by angle steel ***-Length: 6M ***-normal run-out table **-length decided by end switch electrical components and control system of the C channel **0x*7x*5mm roll forming machine ***-Apply normal electronic components to control ***-length decided by switch ***-apply to stop to cut-off ***-voltage: **0V.*0HZ: ***-Incoming material: Hot-rolled carbon steel Coil ASTM A**0 G*0 or semi hard. ***-Thickness of incoming material: 1.5—2.5mm