Description
The basic non-pressure system SWH is a passive system, which relies
on a natural principle-Thermosiphon. There is water in evacuated
tubes and free to flow into tanks. When the water in
tubes is heated by sun’s rays firstly, this makes water in the
tubes lighter. Therefore the cold water
in the tank move downwards and hotter water move upside into the
tank. It is an open circuit since
the air vent and the overflow pope is open to the air.
Â
All the storage tanks are tested before leaving with tested
pressure of 0.*5MPa (0.5bar). But the
operation pressure should be 0 MPa. The daily efficiency is over or
equal to *0 % normally and *2%
in winter. We welds the inner tank by high-frequency ring or argon
arc techniques
Â
Specification: (we can customize according to customers’
requirement)
- Inter tank: SUS ****2B food grade stainless steel with thickness
of 0.*1mm
- Out tank: galvanized steel/colour steel of 0.*1mm
- Capacity: ******0L
- Evacuated tubes: dia. *7mm****0mm, *8mm****0mm
- Insulation layer thickness: *0 mm
- Bracket: galvanized steel with thickness of 1.5mm
- Heat preservation: *2 hrs
- Hail resistance: *5 mm
Working pressure: 0 MPa
