Description
FEATURES:
1.Hydraulic Decoiler with Break is
equipped for roll forming production, not manual one.
2.Manual Blade Shearer before Roll Forming is the essential for
roll forming production, and length control is set on touchable
screen, so that material is calculated by PLC for each material
thickness and color production.
3.Refine steel plates in *2 – *5 mm as Sidewall of machine is
used.
4.*0 – *0 Nos of Rollers is used for roll forming, ensuring profile
strength.
5.Mitsubishi (Japan) PLC and 5.7'Touchable Screen are used for for
data processing and setting.
6.Roll forming speed is 0 – *0 meters / minute.
7.Upper and lower layer production is exchanged by clutch.
TECHNICAL PARAMETER
DOUBLE LAYER ROOF PANEL ROLL FORMING MACHINE
(1)Suitable Material: PPGI Coil / Embossed Aluminium Coil
(2)Material Width: **4 / ***0 / ***0 / ***0 mm
(3)Material Thickness:0.*0 *- 0.*0 mm
Production Process:
decoiling – manual shearing – roll forming – cut-off after sizing –
final roof panel
Composition:
1.8 – *0 tons hydraulic decoiler: ***0 mm width; Ø **0 – **0 mm
inner diameter; 2.0 kw
2.Manual shearing device before material feeding: PLC calculating
and controlling, material saved, no wasted; blade cutter
3.Roll forming machine: *0 – *0 Nos roller station; Ø *0 mm main
shaft; *2 – *5 mm machine sidewall thickness; 0 – *0 meters /
minute; production exchanged by clutch
4.Hydraulic cutting-off: Gr*2 steel blade; *0 tons working table
pressure; with fan-cooler; 4 kw
5.Simple run-out table: 4 pieces, in 8# channel steel
6.PLC controller: Mitsubishi PLC; 5.7" Mitsubishi touchable screen;
Japanese frequency converter; Schneider electronic components
