Description
Drive-in racking consists of upright frames, top beams,
top & back bracings, support bars, support rails, etc.
High-intensive structure, the depth of racking is
mainly composed of support bars and rails, which connect upright
frames tightly. One tunnel of single-side drive-in racking
should be stored less than 8 pallets, double-side racking
should be stored less than *5 pallets.
Besides, unit weight of one pallet + goods should be within ***0kg,
and the unit height should be within ***0mm. Drive-in racking
uses space highly, almost two times than selective pallet racking,
and the cost of one position of one pallet is more low, so it
is very suitable for storing small variety but large quantity
goods.
The way of operating pallets is first-in last-out, but this kind of
drive-in racking is not very stable, so the racks can’t be so
high, normally below *0m. Besides, the loading of one
pallet can’t be too heavy. This kind of racking is normally used in
dairy food, beverage, tobacco and so on, as well as some cold
warehouses .
Analytical drawing of each parts:
A. Upright frames & protect
rails: one frame consists of two uprights +
H-bracings & D-bracings + bolts & nuts, stable
structure.
To avoid crashing when forklift entries into the tunnel of racks,
we designed the protect rails in the bottom of frams, and in the
two
ends of one tunnel, we still put foot protector, normally, the
protector is **0mm high.
B. Support bar: be
pressed in whole structure, no welding, good loading capacity, and
nice look. When connecting with uprights,
the special safety pins should be used, the pins can make sure
the bars not fall down when the racks suffer crash. There
are
single-side bar and doule-side bar, the single-side bar is
used in the two outsides of
racks’ system, the double-side bar
is used
in the middle of racks.
C. support rails: be
made of good quality cold steel, 2.0mm or 2.5mm thickness, be
choosed according to loading request.
