Sell LZS Double Suction Axially Split Casing Centrifugal Pump

Description

Design Feature:

The casing is axially split wiht the suciton and discharge branches locatd in the lower half-this allows the complete pump rotor with bearings to be removed for maintenance without diusturbing the main pipework and valves.
The pump shaft runs in either grease or oil lubricated rolling bearings with the rotor located by the non drive end bearing which also accomodates any residual axial thrusts from the hydraulically balanced impeller.If required the radialk loads can be carrried by oil lubricated sleeve journals.Sealing of the pump shaft is effected by packed stuffing boxes or mechanical seals and the shaft sleeves fully protect the shaft in the waterway right up to the impeller hub.The shaft can be reversed to allow the pump to be driven fro meither side. Flanges are normally to DIN or ANSI standards but BS and other standards dcna be considered on request.

Operating Data:
Sizes                        N.B.5 to *0 in.
Capacity                  up to ****0m3/h
Head                        up to **0m
Working Pressure  0.4~6.4MPa
Working Temperature **0~**0C

Application:
The LZS pump is suitable for pumping clean liquids with some tolerance of slight contamination by solids over a wide temperature range.
for water treatment and supply
in irrigation and drainage systems
in power stations, heating systems and district heating plants
in the paper and pulp industries
as marine ballast and cvooling water pumps
in sea water desalination plants
as pipeline pumps and pressure boosters
in process engineering
for offshore duties
LZS pumps can also be used as engergy recovery turbines.

Please detail your specification when you make inquires.