Description
Duct auto line
III:
Products
Information
Dingcheng
provides compact lines for small and medium sized duct factories
and duct installation contractors. Compact line can be either a
stand alone system or the start of a complete automatic fabricating
system. It is the starter of duct manufacture, also it can be taken
right to the construction site. Its control system adopts specific
software and realizes one person operation, which saves labor
cost.
Features:
√ Twin-motor driven
dual-decoiling, selectable coils stand by, maximum capacity of
*-ton per station (optional: up to **-ton per station)
√ Straightening/flattening
-Air pressure controlled six(6) rolls straightener. No adjustment
required when changing from *8 to *7 gauge (0.**1.2mm)
material
√ Air
pressure controlled ring type beading rolls with five beading
rings-optional by remove beading rings or uplift the beading
rolls
√ Accurate PLC control
unit, Preset cutting size , touchscreen-easy operate
√
***8m/min feeding speed,fast acting back gauge,7 seconds per
cutting for a 1m length sheet metal
√ Preset
available profiles and folding style, notching size,punching
size,cutting dimension on touchscreeneasy operate
√ This
auto line will process 4or 5galvanized steel into blank for
plasma cutting machine or notch blank for L section or full
ductwork
√ Bends
right angle lock
Capabilities:
√ Alternative width for
4(***0mm) or 5(***0) material
√ Thickness: ****7ga
(0.**1.2mm)
√ Shearing tolerance of
±0.5mm
√ Hydraulic folding
diagonal tolerance of ±0.5mm
√ ***4FPM
(***8m/min) feeding speed,fast acting back gauge
|
Model No.
|
Max Coil Width
|
Thickness Range
|
Speed
|
Shearing Tolerance
|
Diagonal Tolerance
|
|
DC**1.2x***0
|
***0mm
|
0.**1.2mm ****0ga
|
***8m/min ***9FPM
|
±0.5mm
|
±0.5mm
|
|
DC**1.2x***0
|
***0mm
|
Stations:
coil-straightening-beading- punching square
-notching-folding-shearing
Note:
1.Cut to
length or cut blank for plasma cutting machine
2.1 Punching
and notching for “C” “S” cleat duct. It can cut different types of
notches such
as ”L”, “U”
and “壔.
It can also cut blank for “C” and “S” cleat flange
machine.
2.2 Cutting
blank for TDF flange machine. It can be used with TDF flange
machine and folding machine.
2.3 Cutting
blank for angle iron flange or “Z” shape flange machine.Used with a
vertical seaming machine to get a full wrap duct.
3. Cutting
blank for TTF/LT mate flange. Used with a vertical seaming
machineand mate flange machine to get a full wrap
duct.
