Description
KRONE MODULE Reed
Disconnection
It is made up with
the plastic shell and reed terminals for the cable continued
connecting into the side of a module. The over-current and
over-voltage protection to switches and other communications
equipment can be realized if it worked with the security unit.
1,The clamp module compatible with the
KRONEÂ Â Â Â Â LSA-PLUS SERIES
module.
2,The point of contact design is based on the principle of
airtight, it formed a reliable connection between the reed and the
cable.
3,Size: (H x W x D): **2.5mm x *1.5mm x *0.5mm (*0 pairs)
4,Environmental conditions: temperature 5 ~ *0 ℃; Relative
humidity <*5% (**0 ° C); Atmospheric pressure *0 ~ **6KPa<br
/> 5, Pulling-out force: tin bronze, silver plating (*0 ~
*0uinch)，appropriate diameter 0.4 ~ 0.6mm,
pulling-out force not less than *5N.
6, Flame retardance: plastic parts are made of PBT or flame
retardant ABS, Combustibility should be achieved GB / T ***9.*****5
standard.
7, Insulation resistance: under the standard atmospheric pressure,
between any one of two terminals unconnected, the insulation
resistance is not less than ***0MΩ.
8,Intermediate resistance between reed terminators:no more than
7mΩ（under standard atmospheric
pressure, between any one of two terminals
unconnected）.
9, Intermediate resistance: no more than 7mΩ under standard
examination condition.
*0 Life: durability
**0 cycles.
*1, Types and specifications: *0 pairs, disconnection module.
For cable splicing into the side of a module. The over-current and
over-voltage protection to switches and other communications
equipment can be realized if it worked with the security unit.
Environmental requirements:
       1) Operating
Temperature: *5 ℃ ~ *0 ℃
       2) Storage
temperature: **5 ℃ ~ *5 ℃
       3) Relative
humidity: ≤ *5% (**0 ° C)
       4) Storage
relative humidity: ≤ *5%
       5) Atmospheric
pressure: *0KPa ~ **6Kpa
*2, Module indicators:
      1) Lead material: single
strand of plastic insulated wire;
      2) The wire diameter:
0.**0.6mm;
      3) The maximum outside
diameter (including insulation included): ≤ 1.4mm
      4) a single wire along
the notch perpendicular to the direction of the pull-off strength:
≥ *5N;
      5) protector spring and
wiring of the contact pressure between the terminal piece: f>
*0g
Â
