Description
This product is an
automotive electronics device which based on J***2 standard
interface, it can do tracking, abnormal alerting, remote
maintenance and configuration, it has integrated the GPS, GPRS and
intelligent control technology all in one.
This product composed by GSM and GPS module with built in
G-sensor and external GPS antenna (optional), it is a plug and play
device to OBD II interface.
1 GPS
This product has a built-in GPS receiver for enabling global
positioning.
2 Real-time Monitoring
This productcommunicates with control centerviaGPRS for
monitoring purpose.
3 Roll Call
When device receives roll call command from center, it will
upload GPS positioning information to center immediately.
4 Fixed Uploading
Device will report GPS information to center according to
pre-set fixed uploading interval.
5 Compressed Uploading
The useris allowed to set capturing 8 GPS info pack and
transmit to the control center.
6 Power Failure Alert
Device hasabuilt-in battery,it sends alarm to center when it
is been disconnected.
7 Low voltage alert
Device sends low voltage alarm to the control center when the
external voltage is lower than 9V (Once only)
8 GPS Failure Alert
When the malfunction happens on GPS or the device is not able
to be positioned in long time, it will send GPS failure alarm to
the center.
9 Over Speed Alert
When vehicle’s speed exceedsthe presetthreshold, the device
will uploadspeedingalarm to center.(default setting is
**0km/h)
*0 Geo-fenceAlarm
Set a zone and enable this function, the device will send
alarms to center when the vehicle is out/in the zone, including the
zone No., device rectangle setting index, meanwhile enable/disable
the alarm function(maximum *4 zones are supported)
*1 Data storage/supplementary report in blind
Area
When GPRS signal is not available, the device will capture GPS
info based on the preset upload interval and transmit to the center
when GPRS is reconnected.
*2 Mileage of Trip
The devicereport mileage to center in each uploading
pack
*3 GPRS/SMS dual mode communication
The device supports GPRS/SMS dual mode communication; the
alarm info will be reported in SMS
*4 Working mode
Device supports two working modes: Non-power save mode and
intelligent power save mode
*5 User Alert
