Sell E1 to Fiber Optic Modem

Description

Introduction:
MODEL***1 Optical Optic Modem converts E1 electrical signal into optical data stream for transport over single mode or multi-mode fiber optic cables. At the opposite end of the fiber, the optical stream is converted back into electrical signals of the appropriate interface such as G.**3 & V.*5. This fiber optic modem extends the transmission distance up to more than **0Km. The frame format of MOD-E1 is unframed for E1, so it can be used to transmit E1 signal of unframed video. 
Features:
1.Lucency transfer E1(G.**3) protocol
2.Support optic fiber loop and E1 port loop
3.Choice ST, FC, SC connector
4.E1(G.**3)interface support **0ohm(RJ**5) and *5ohm(BNC)
5.Multi-mode 2KM, signal-mode *****0KM

Specifications: 
Optic interface
Line mode type: CMI 
Line mode rate: 2.**8Mbps 
Operating wavelength: **0nm,***0nm or ***0nm 
Optic fiber connector: multi-mode adopt ST connector
                  single-mode adopt FC/SC connector
Transmission distance: Single-mode: *0,*0,*0,*0,**0,**0km 
 Multi-mode: 2km 
E1 interface
Standard：ITU-T G.**3  G.**4 
Data rate: 2.**8Mbps
Working: Asynchronism Transparent transfer
Operating mode: HDB3
Impedance: *5Ω, physical interface BNC;
          **0Ω, physical interface RJ*5 
Protection: ***0V electronagnetism isolate
Structure
Independent: **7.4mm (depth) ×**6.3mm (width) ×*2.6mm (height) 
Rack-mountable: *9in 4U standard casing 
Power supply
Input power:**0VAC or *8VDC 
Power consumption: 2W 
Environment
Operating temperature: **5°C～*0°C
Storage temperature: **0°C～*5°C
Humidity: 5%～*0% (free of condensate) 
Warranty: 5 years
Approvals: FCC, CE, RoHS approvals