Description
Shaghai Tarzan
inertia gravity classifier for
sale  Â
Â
Introduction:
TZ
inertial gravity classifier is a new type of classifier developed
by Tarzan according to customers’ reaction and requirement. It is
always used together with a duster and without motors. It heavily
reduced the investment cost and operation cost, and is mostly used
for the separation of excessive powder in dry sand making
line.Â
Â
Application:
Dry
sand making production line
Features;
1. Easy to adjust, 4 parts for adjustment as: material falls
control, first ventilation control, secondary ventilation control,
finished volume control. It can control the air flow and powder
content very conveniently.
2. Power saving, previous solution is classifier+duster, but
at this moment no motor in this kind of equipment, the main power
is focus on duster. Thus it saves the electricity input.
3. Simple structure, few material contract parts, little
abrasion, low cost of maintenance.
Advantage:
1. Low cost of maintenance and operation
2. Reduce the moisture content, minimize the cost
3. Develop the market of granularity of **0 mu material.
Principle:
By the
control of air flow, flow direction and gravity, the inertial
gravity classifier can realize **4.*5mm material classification.
The fed material and primary air enters into the classifier from
the top, the direction of air flow changes **0°, and leaves the
classifier with fine particles through the blades. The coarse
particles falls down to the bottom of the classifier because of the
gravity itself then can’t be flowed with the air, and discharges
from a valve.Â
Secondary
air blowing from the bottom of the blades passes the curtain of
falling particles mandatorily. These coarse particles nearing the
classification point enters into the eddy in the heart-shaped
cavity secondary air flow which changed its director. When enter
the classifier, the captured fine particles and other particles
pulled by the eddy all gather into the powder collector and will be
recycled at last.Â
The air
throttle of secondary air can be adjusted simply by hand. It can
change the particles granularity of classification. There is no
moving part in material flow area, so the maintenance requirement
of this machine is the lowest. For abrasive material, liners are
used in some area in order to guarantee the long operating life of
equipment.