KNX/EIB, IP Interface, k-bus, GVS

Description

The KNX IP Interface is designed for an intelligent building control system, which is used for facilitating communication between the Ethernet network and the KNX system. 
The KNX IP Interface connects the EIB/KNX system with the Ethernet network via an Ethernet RJ*5interfacein the front，It serves as an interface between KNX installations and IP networks and can configure, parameterize and commission the EIB/KNX installation as well as bus monitor via the LAN using the ETS(ETS3 or later)software.
For operation an additional *0V DC supply is necessary.The bus connection and auxiliary power supply connection are carried out via using EIB bus connection terminals.
The device adopts an Ethernet RJ*5interfaceto connect with LAN network. The network interface can be operated with a transmission speed of *0/**0Mbit/s Auto Sensing.
The IP address of the device can be fixed or can be received from a DHCP server. If you need to remain the IP address static or here no DHCP server on the network, you can assign a fixed IP address to the device via ETS. The application program is preloaded in the factory, the IP address is fixed, and the port number is set to ***1. (Note: the device cannot program itself, but need via other communication interface device to program it.)
The KNX IP Interface is able to use the Engineering Tool Software ETS (ETS3 or later) with a VD4 file to allocate the physical address and set the parameter. The factory default physical addresses are *5.*5.**5, and the address can be modified directly via local interface settings of ETS.
The KNX IP Interface is a modular installation device. It can be installed in the distribution board on *5mm mounting rails according to EN *0 **5.
This manual provides the technical information about the KNX IP Interface as well as assembly and programming in detail for users, and explains how to use the interface device by the application examples