Description

The switch actuators are the modular installation devices, with 8 and *2 outputs for selection, using EIB bus
connection  terminals  to  connect  to  the  system.  The  switch  actuators need  to connect an extra **0V AC  power
supply and provide to 4 outputs. It is able to use the Engineering Tool Software ETS (ETS2 v1.3 or later) with a
VD2/VD3 file to allocate the physical address and set the parameters.
If  the  **0V AC  power  supply is  not  connected,  all  LEDs are flashing  for  indicating  output  state  on  the
device.
It is able to switch from 4 to 8 independent electrical AC loads or three-phase loads and 4 electrical AC loads
with  the  same phase of  the  **0V AC  power  supply by  the  switch  actuators  with maximum  output  of  *6A  per
output and manual switch, as well as visible switching status via LED indication.
There are same following programming functions for each output:
  time function: on/off delay
  staircase function with the warning and adjustable staircase lighting time
  scene, preset control: 8bit/1bit
  logic operation: AND, OR, XOR, gate function
  status response
  forced operation and safe function
  threshold function setup
  control of electro thermal valve function
  manual operation switch
  indication of switch status (contact position)