Description
Advanced High-efficient AAC Concrete Brick Making Machine
The aerocrete produces the technological process:
1. The raw materials store in the material storehouse (or stores
the pot) after dealing with reserve such as lime, cement, gypsum,
sand (or fly ash)
2. Aluminum powder or aluminum lotion is through dealing with the
reserve material for use
3. Raw materials measure according to certain matching by electron
balance measure, aluminum powder, water put into aluminum powder
mixer is it is it suspend the liquid to make to mix after
measuring
4. The batching water (cold water or hot water pitcher hot water)
is measured by the electronic water balance
5. Put into and pour among the mixers in certain order after, raw
materials, aluminum powder suspend the liquid is measured, pour and
enter the mould after mixing evenly (panel should be put network
slice of reinforcing bar in advance in the mould)
6. Quiet to is it raise in advance to park through certain
temperature and time, is it transport to the cutting machine to
hang from upset hoist upset *0° after the base body reaches certain
intensity, the drawing of patterns is cut
a. The base body carries on the side and cuts and mills the trough
vertically
at first
b. Then carry on the vertical level to cut
c. Cut horizontally finally
d. Cut good base body, raises to cauldron car go on one yard of
shelves organize into groups to steam to transport to hang to drive
a vehicle to load
7. Raise products well, produce after the cauldron breaking the
board off with the fingers and thumb by the board breaking off with
the fingers and thumb machine to steam
8. Pile from finished product hoist or forklift to finished product
field pile the buttress according to specification to carry
9. Steaming and raising the car and side board and entering the
next board of circulation and returning after, the finished product
is unloaded, with upset hoist mould frame association that drawing
of patterns get off, restore *0°return to pour mixer pour again
after clearing up
