Description
Blue classic waterproof
coatingis used in polymer synthesis of
two-component waterproof coating, using imported raw materials,
unique formula design, the liquid mixed with powder to produce
chemical reaction, the strength of the formation to form a layer of
jointless high elastic waterproof membrane, high adhesion of
coating and substrate, can be used for long-term immersion
environment, at the same time also has a certain flexibility, can
resist mild concussion and tiny displacement at the grass-roots
level. Blue upgrade plugging effect is better, more assured
waterproof.
features
1, construction is convenient, can be directly in the wet ground
construction.
2. Excellent tensile performance, able to resist shrinkage and
cracking and slight vibration caused by temperature difference of
base surface.
3. Good bonding performance. The coating penetrates into the
substrate to achieve full adhesion without empty drum and water
channeling, and can seal the loose substrate, special-shaped parts,
pre-cast joints and basal surface cracks.
4, durability: with synthetic polymer excellent weather resistance,
can be durable waterproof.
5, environmental protection: non-toxic and harmless, no smell, is
the national key recommendation of green waterproof materials.
6, formula upgrade, blue classic latest formula, waterproof effect
is better.
scope of application
Especially suitable for kitchen, toilet, pool, exterior wall and
other indoor and outdoor waterproof works, also can be used for
basement, underground garage, bomb shelter, underground tunnel,
subway culvert waterproof
technical indicators
The implementation of the national standard GB/ t*********9
"polymer cement waterproof coating" standards.
Solid content *0%; Fracture elongation **0%; Adhesive strength
0.*0mpa
use method
1. Base surface treatment
Clean and level the base surface to keep no cracks or looseness;
Angle of Yin and Yang made into arc Angle; Smooth out sharp
points.
2. Node location processing
Wet the base surface with water, strengthen the yin-yang corner,
pipe through wall, floor drain and construction joint with flexible
waterproof coating and glass fiber cloth, with a thickness of about
1.0mm.
3, waterproof coating brush
Wet the base surface, maintain a certain humidity but no water,
will be in proportion to stir the waterproof coating directly brush
on the base surface, pressure brush several times; After the first
layer is not sticky, directly brush the second layer (each layer is
about 0.6mm, cannot be too thick); General waterproof need to brush
more than two layers, the last time in the waterproof layer is not
dry in the above scattered sand, can enhance its adhesion with the
protective layer. Brush the edge of the coating several times after
the head; Wait until the waterproof layer is completely dry and
solid.
4, waterproof protective layer
After the waterproof layer is dry and solid, 1.***0px thick cement
mortar protective layer can be made according to the demand.
5. Powder: liquid =3.5:1.5
6. Reference quantity: thickness 1.0mm, about 1.**2.0kg /m2;
Thickness 1.5mm, about 2.**2.7kg /m2. This dosage is for reference
only. The actual dosage may vary slightly due to different
operating conditions and base plane.
k*1 blue classic waterproof coating
notes
1. After the coating is mixed evenly, it should be used up in one
time.
2, the construction temperature is suitable for 5 ~ *5 degrees
Celsius, ensure air circulation during the construction.
3, within two days after the construction, pay attention to rain,
strong sun or cold; Wash tools and equipment with water immediately
after use.
packaged and stored
5kg, *0kg, *0kg drum, with a shelf life of *4 months.
In addition, customers can adjust different colors, such as green,
black, red, etc.
alice at sgfengyuan dot com
