Description

SYSTEM INTRODUCTION:

Model: L32-01
This safety system should turn on strictly by S1s2-S3 sequence,
after confirming there is nobody stays in the room (Press S1),
then close the door (S2) and finally turn on the administrator switch (S3),
then the light can be turned on and the disinfection is started.

Description:
UV emitter parameters: Input: 100-120VAC 50/60HZ 80W
Sensing category: PIR sensor + Microwave sensor
Sensing angel: 120 (PIR sensor) 360° (Microwave sensor)
Sensing distance: 2.8m Sensitivity: 0.3-1m/second

S1 Controller parameters:
Input: 100-120VAC 50/60HZ 
Output: 3A
Timing: 30mins, 60mins, 90mins, 120mins
Installation ways: surface mount