Description
Low-cost jack with rack
idler
Use: it allows idling motion transmission - perfect for
raising or lowering the rows of bottle tracers (see
diagram on page **6). suitable for low-load applications where
the maximum torque required is
4.5 Nm.
State of supply reduction gearbox in reinforced polyamide
complete with 1 worm screw in phosphated
steel, 1 metal gearwheel (reinforced), 1 rack in galvanised
steel with end-stop composed
of a UNI***9 M6x*5 hex head screw and M6 screw washer, 1 knob
fastened with a UNI***9 M6x*2 hex head screw and M6 screw
washer and 1 polyamide screw cap, 4 UNI***9 M6x*5 hex head
screws, 4 UNI***4 M6 self-locking nuts and 8 M6 screw
washers.
Characteristics: motion transmission to the driven reduction
gear Part ***4
occurs by means of the hexagonal transmission shaft.
The brake eliminates loss of position caused by external
factors (e.g. vibrations).
Warning:in order to protect the internal
transmission devices, if you use the knob for movement,
the brake will not fully lock the position.
Standard pack: 4 pieces.
C TECHNICAL DATA:
Nominal torque transmissible: 4.5 Nmthe knob
with torque limiter slips when reaching 4.5 Nm protecting
the reduction gear from overloads).
Rack's travel per turn: 1 knob turn = 8 mmof rack
travel.
Reduction ratio i=*6 (*6 knob turns -worm screware
equivalent to 1 turn of the worm gear with hexagonal
seat).
Operation: manual, if motor-driven max. *0 rpm;
max time: 1 min;
STEP BY STEP (NOcontinuous operation).
On/off ratio=1/9
