Message Master 4000

タイトルまたは説明

• Ease of use
  Absolutely no programming or technical knowledge is required to use this system. Any computer can access its HTML web-based control panel using Internet Explorer, Mozilla Firefox, Google Chrome, etc.

• Intuitive user interface
  Although Message Master ***0 is rich and complete in functionality and performance, configuring it to user specific requirement is a breeze.

• Flexible User configuration
  Configurable easily with any local or remote computer. Only authorized with the correct user ID and password can access Message Master ***0.

• Remote access
  Not only Message Master ***0 can be connected to any computer in the local area network (LAN) environment, it can also be easily setup for remote access and control over the Internet.

• Standalone operation
  Message Master ***0 only need to connect to the equipments to be monitored. No PC or server is required. The PC is needed only for configuring its operating parameters and for viewing the status of the equipments. Network ready.

• Expandable
  Additional Input-Output expansion boxes, temperature monitoring, industrial controllers, even third party software can communicate with it via standard TCP/IP protocol.

• Microcontroller based design
  It is not a PC hardware and does not contain moving parts like hard disk, CD-ROM drive that can affect its reliability.

• Low power consumption
  Because it does not consume much power, Message Master ***0 does not generate heat and will run for *4 hours without worries of breaking down. In the event of incoming power failure, it can operate for hours on a small capacity lead acid battery / power supply unit.

• Small & Compact
  The dimension is **5(l) x *8(h) x **0 (d) mm and weight a mere **0 grams, it can be fitted into any chassis or equipment cabinet or be obscurely installed in any corner of the equipment room.

• Repeat SMS
  If enabled, when an alarm is triggered, the SMS will be sent to the operation and forward group repetitively at the interval specified during software configuration. To cancel repeat sending, any mobile phone from the operation or forward group must acknowledge to MM***0 by replying the acknowledge command. Once MM4K received the acknowledgement command it will stop sending further SMS for this trigger.

• Automatic Health Check
  The “Auto Health Check” message allows user to check, via SMS or enable to auto check that the MM***0 unit is functioning properly: If “enable” is checked, MM***0 will send a SMS message on scheduled system date and time. If the auto health check is not enable, user still can perform manual health check by sending a SMS health check command.

• Remote Phone Management
  Re-assigning of operation personnel, a change of mobile phone number is also common. Rather than having to physically go to the installation site with a notebook computer, the authorized personnel can perform the change from anywhere using their mobile phone. Where there are many installed sites, distance or time is a concern, this becomes very efficient.