Silicone Rubber

タイトルまたは説明

Description: Silicone Rubber

• HY***8# silicon rubber is mainly used for toy gifts and craftwork gifts with the advantages of good tensile strength, high tear strength, high temperature resistance, high duplication times and repeated use, etc.
• It is suitable for small products or fine and precision products which is difficult to demould.
• This silicone rubber is one of the products with the highest use level in the production of craftwork gifts and the shrinkage is up to 2‰.
• Applications: poly technique, lightings, candles, and molds in multiple pieces for large products.

Standard datasheet:

• Model appearance viscosity (cs) hardness (Ao): **********0.
• Tensile Strength (kgf/cã�¡): ****5.
• Tear strength (kgf/ã��): ≥*5.
• Elongation (%): ≥*5.
• Mixing ratio (%): ≥**0.
• Operating time (h): 2~3.
• Curing time (h): 0.5.
• **8 white: 2~4.

General description:　　

• RTV*2 molding silicon rubber and silicone rubber are general called two-component room temperature vulcanization silicone rubber with excellent fluidity and good operational performance.
• Add curing agent of 2%*3% at the room temperature, the silicone rubber is still operational within *0 minutes, and in **3 hours, an elastic silicon mold will be obtained with resistance to deformation, high-temperature, acid and alkali and expansion.
• The silicone rubber is mainly applicable to mold duplication of poly crafts, resin craftworks, lightings, candles, etc. and fabrication of precision molds.

Operation instruction for RTV*2 molding silicone rubber:　　

• The product is white or red flowing liquid with general hardness of *2—*0A°after curing.
• If the customer wants to make large products and large size molds, the mold should be made of silicone rubber with high hardness.
• On the contrary, if the mold with fine and precision patterns, it should be made of silicon with low hardness.
• The amount of the curing agent depends on the actual requirements of the customer.
• If molds requiring fast drying and demould, more curing agent is needed; contrarily, if molds requiring slower drying and demould, less curing agent is needed.

Note:

• our company does not recommend you to add silicone oil.
• If a special soft silicon mold or fine detailed and complex patterns products are required, 5%**0% silicone oil can be added to soften the mold for easy demould.

The proportions and reactions of the curing agent and the silicon are listed as follows:　　

• Adding curing agent 1%, the silicone can still be operated within 2.5 hours and can be demoulded after **8 hours.　　
• Adding curing agent 2%, the silicone can still be operated within *0 minutes to 1 hour and can be demoulded after **3 hours.　　
• Adding curing agent 3%, the silicone can still be operated within *8 - *0 minutes and can be demoulded after 1.**2 hours.
• Adding curing agent 4%, the silicone can still be operated within *0 - *5 minutes and can be demoulded.