タイトルまたは説明

MainFeatures:

1) There is a negative feedback compensation circuit in the output, so it can regulate the voltage (****0V) stably, continuously and precisely.

2) The function of memorying.The voltage regulator can raise the voltage from "0V" to what you set as before you shut it down last time when it starts to work this time.

3) The function of starting analog output softly is more practical, each time when it starts to work, the voltage regulator can raise the voltage from "0V" to what you set as before you shut it down last time slowly, and keep the output voltage stably. Therefore, the heating electronic component would be protected from high voltage and prolong the service time.

The YL-ZKG, temperature controller of voltage regulating type, especially fit to control temperature in the situation and equipment which is controlled by multiple-point temperature and serious thermal crosstalk, like bottle-blowing machine, film-blowing machine, blister machine, extruding machine, sheet machine and so on.

 The Function of Panel Buttons

1)"MD": Mode selection key for: presetting, reviewing or confirming settings and parameters.

2)"∨" or "∧" the values to the desired parameters(Range:****0V).

Instructions for users

1)Keep pressing "MD" and "∧" for about 3 seconds, when "Ht" is displayed on the screen above(PV),there is a random digit on the screen below(SV),users can press "∨" or "∧" to regulate the time for soft starting(that is the length of time for raising the voltage from "0V" to how much you have set in the regulator after it Start to work). When it is done, press "MD" to storage and exit the menu.

2)The time regulating range of soft start is:"***0" ("0" for shutting down the soft-start,"***7" for fast soft-start,and"****0" for slow soft-start )

Ps.Because of different restriction of voltage set (e.g.*4V, **0V, **0V),when setting the same value of soft-start time (e.g."*0") ,the raising rate of the voltage displayed on the meter is impossible synchronize with the actual value of time.

1) Half wave power supply is strictly prohibited because of the circuit design of negative feedback compensation, or the negative feedback transformer would be destroyed by the direct current.

2) YL-ZKG is not fit to control the perceptual load components and situation like induction furnace and step-down transformer.

3) If the output of SSR-DV is not all conducting, or the output signal is not stable, that must because the signal controlling line(T1) and negative feedback signal line(G) connect counter. Just swap T1 and G will be fine.